MiLAN MIL-RCM16A Spezifikationen PDF herunterladen (Seite 58)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

PLATFORM RAISES HALFWAY & STOPS

TROUBLESHOOTING

 GRAVITY DOWN LIFTGATES: Lower the platform to the ground. Clean dirt and

ﬂ uid from top of reservoir in pump box. Fill the reservoir to correct level indicated

on sight glass (pump box).

2. Find out if vehicle is equipped with optional battery box, truck charge line, tractor charge

line, or trailer charge line. Check optional battery box cables and charge line cables for

damage, dirty connections and loose connections. Replace damaged battery cables,

clean dirty connections, and tighten loose connections.

3. Check if vehicle batteries and optional battery box batteries are fully charged. If required,

fully charge batteries with a battery charger. Replace batteries that cannot fully charge.

If battery charger fully charges batteries, use vehicle manufacturer’s speciﬁ cations to

check the vehicle battery charging system. Do not operate Liftgate if vehicle charging

system needs repair.

4. Check pump motor solenoid (FIGS. 55-1 and 55-2) and electrical cable connections

pump box. Make sure electrical cable connections are clean and tight. Use a 6” long,

10 gauge insulated wire as a jumper between motor solenoid terminals “A” and “C” to

activate solenoid. Replace solenoid if it fails to activate.

1. Check the hydraulic ﬂ uid level in the reservoir.

 POWER DOWN LIFTGATES: Raise the platform to bed height. Fill the reservoir to

correct level indicated on sight glass (pump box).

NOTE: For dual pump system, check secondary pump and motor ﬁ rst.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 85 86

Keine Kommentare

MiLAN MIL-RCM16A Spezifikationen Seite 58