MiLAN MIL-RCM16A Spezifikationen PDF herunterladen (Seite 37)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

Avoid making sharp bends in wiring.

CAUTION

29. Position spacer at the 3rd and 4th

coils of the spring guard (FIG. 37-2).

Then, screw the spacer to runner.

NOTE: If replacing LH runner, skip

steps 28, 29, 30, & 31.

To prevent damage to twin hydraulic

hoses and ﬂ exible cable, ensure the

hoses and cable are routed correctly

inside the spring guard and are not

twisted. Cable must not be wrapped

around the hydraulic hoses.

CAUTION

27. Bolt the upper and lower pads

(FIGS. 37-1A & 37-1B) on the

runner (FIG. 37-1C).

28. Place spring guard with ﬂ exible cable

and twin hydraulic hoses, in channel at

bottom of runner (FIG. 37-2).

30. Reconnect runner switch cable to ﬂ exible

cable at bottom of runner (FIG. 37-2). Use

clamp and lock nut to fasten molded portion

of connector to runner (FIG. 37-2).

NOTE: MAXON recommends using

dielectric grease on all electri-

cal connections.

FIG. 37-2

NOTE: To reinstall the pads, use

the same shim setup

that was removed with

the pads. Maintain .030”

clearance between pad

and guide in the column.

UPPER PAD

FIG. 37-1A

FIG. 37-1C

LOCK WASHER

(2 PLACES)

BOLT

(2 PLACES)

LOCK WASHER

(2 PLACES)

BOLT

(2 PLACES)

LOWER PAD

FIG. 37-1B

RUNNER

FLEXIBLE CABLE

CONNECTOR

CLAMP

LOCK

NUT

HOSE

SCREW

SPACER

TUBE

SPRING

GUARD

RUNNER SWITCH

CABLE

CONNECTOR

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

MiLAN MIL-RCM16A Spezifikationen Seite 37

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein MiLAN MIL-RCM16A