MiLAN MIL-RCM16A Spezifikationen PDF herunterladen (Seite 26)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

REPLACING PARTS

LIFTING CYLINDER REPLACEMENT - Continued

11. To install new Lifting cylinder, reverse Steps

6, 5, 4, 3, and 2.

FIG. 26-3

NOTE: To install cylinder correctly, make sure hydraulic lines on cylinder are facing

the vehicle body.

NOTE: Before installing a new cylinder, get a helper. Have the helper look through

square inspection hole on back of runner while cylinder is lowered. The helper

can inform installer when rod end of cylinder is lined up with lower pin.

9. To help remove air from rod end of

housing, position cylinder on its side

with the lifting line on top (FIG. 26-1).

Then slowly return cylinder to vertical

position (FIG. 22-3).

CYLINDER POSITIONED ON SIDE

FIG. 26-1

LIFTING LINE

10. Remove extension hose and plug the lifting

line (FIG. 26-1).

12. Raise platform enough to remove jack

stands (FIG. 26-3). Then lower platform

all the way. Pressurize hydraulic system

by pushing control switch to UP position.

Release switch when platform is raised to

bed height.

CYLINDER WITH HOSE REMOVED

FIG. 26-2

13. If necessary, do the BLEEDING

HYDRAULIC FLUID procedure in

this manual.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 85 86

Keine Kommentare

MiLAN MIL-RCM16A Spezifikationen Seite 26