MiLAN MIL-RCM16A Spezifikationen PDF herunterladen (Seite 19)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

1. Lower the platform to ground level.

Check if tip of the ﬂ ipover and bot-

tom of the runners touch the ground

at the same time (FIG. 19-1).

TIP OF

PLATFORM

BOTTOM OF

RUNNER

GROUND

TIP AND RUNNER TOUCHING GROUND

FIG. 19-1

RUNNERS NOT TOUCHING

FIG. 19-2

BOTTOM OF

RUNNER

2. If the bottom of the runners are off the

ground, measure the distance “H1”

(FIG. 19-2) from the ground to the

bottom of the runners.

• Adjustment is not required if

distance “H1” is 1” or less.

• If distance “H1” is more than 1”, refer

to the steps that follow to adjust the

platform chains.

”H1”

GROUND

MEASURED “H1”

(AT RUNNER)

ADJUSTMENT METHODS

(

•

REQUIRED FOR EXPECTED RISE AT TIP)

EXPECTED RISE

“H2” (AT TIP)

ADJUST U-BOLT

(RAISES TIP 0”

TO 1-1/4”)

REMOVE 1 LINK

OF BOTH CHAINS

(RAISES TIP 1-1/2”)

REMOVE 2 LINKS

OF BOTH CHAIN

(RAISES TIP 3”)

1” - 2-1/4”

•

--0” - 1-1/4”

2-1/2” - 3-3/4”

••

- 1-1/2” - 2-3/4”

4”

•••

3” - 4”

TABLE 19-1

3. Refer to measured distance “H1” at the run-

ners and TABLE 19-1. Note the method(s)

that will be required to raise the tip of platform

(or retention ramp) the expected distance.

”H2”

ADJUSTMENT

PLATFORM CHAIN ADJUSTMENT

Personal injury and damaged equipment

could result if chains separate from plat-

form under load. Never adjust the plat-

form chains to compensate for excessive

wear. Refer to chain inspection on the

PERIODIC MAINTENANCE CHECKLIST.

Adjustment should only be necessary

when new chains are installed.

WARNING

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

MiLAN MIL-RCM16A Spezifikationen Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein MiLAN MIL-RCM16A