MiLAN MIL-RCM16A Spezifikationen PDF herunterladen (Seite 14)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

PERIODIC MAINTENANCE

CHECKING HYDRAULIC FLUID

1. For a gravity down power unit, open the

platform and lower it to the ground.

3. If needed, add ﬂ uid to the reservoir as

follows. Open the pump cover and re-

move ﬁ ller cap (FIG. 14-2). Add hy-

draulic ﬂ uid to reservoir until the sight

glass looks half full (FIG. 14-1). Re-

install ﬁ ller cap (FIG. 14-2).

GRAVITY DOWN POWER UNIT

FIG. 14-2

CHECKING HYDRAULIC FLUID LEVEL

FIG. 14-1

NOTE: If the hydraulic ﬂ uid in the reservoir is contaminated, do the CHANGING

HYDRAULIC FLUID procedure in this section.

GRAVITY DOWN POWER UNIT

CAUTION

Keep dirt, water and other contaminants from entering the hydraulic system.

Before opening the hydraulic ﬂ uid reservoir ﬁ ller cap, drain plug and hydrau-

lic lines, clean up contaminants that can get in the openings. Also, protect the

openings from accidental contamination.

+50 to +120 Degrees F - Grade ISO 32

Below + 70 Degrees F - Grade ISO 15 or MIL-H-5606

NOTE: Use correct grade of hydraulic ﬂ uid for your location.

See TABLES 15-1 and 15-2 for recommended brands.

POWER DOWN POWER UNIT

2. Check if the sight glass on the pump

cover is half full of hydraulic ﬂ uid

(FIG. 14-1).

1. For a power down power unit, open the plat-

form and raise it to vehicle bed height.

3. If needed, add ﬂ uid to the reservoir as

follows. Open the pump cover and re-

move ﬁ ller cap (FIG. 14-2). Add hy-

draulic ﬂ uid to reservoir until the sight

glass looks half full (FIG. 14-1). Re-

install ﬁ ller cap (FIG. 14-2).

2. Check if the sight glass on the pump

cover is half full of hydraulic ﬂ uid

(FIG. 14-1).

FILLER CAP

SIGHT GLASS

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

MiLAN MIL-RCM16A Spezifikationen Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein MiLAN MIL-RCM16A